Specialist in EMC and thermal management Go to products
Specialist in EMC and thermal management Go to products
Specialist in EMC and thermal management Go to products
Specialist in EMC and thermal management Go to products
Specialist in EMC and thermal management Go to products

Welcome to EEMC

EEMC is a specialized distributor of components, materials, and equipment for EMC and thermal interfacing.

News from EEMC

RF Switching and Signal Levels in Automated RF Testing

RF Switching and Signal Levels in Automated RF Testing

In automated RF testing, signals between the test equipment and the system under test often need to be switched and level-adjusted. When there are multiple test paths, this can result in a complex setup…

Read more
RF amplification for compact drone platforms with limited SWaP

RF amplification for compact drone platforms with limited SWaP

For RF systems on board drones, dimensions, mass, and power consumption are key design criteria. At the same time, RF payloads require sufficient output power across a wide frequency range. A compact amplifier module can help…

Read more
Mobile command post with RF shielding for secure communications

Mobile command post with RF shielding for secure communications

Modern command posts must be rapidly deployable, easy to move, and at the same time provide protection against eavesdropping and electromagnetic interference. A textile-based, RF-shielded shelter offers a practical solution for this due to its light weight…

Read more
Microwave absorption prevents resonances and cross-coupling up to 100 GHz

Microwave absorption prevents resonances and cross-coupling up to 100 GHz

In compact high-frequency systems, metal enclosures, cavities, and other structural components can cause unwanted microwave resonances and mutual coupling. In 77 GHz radars for ADAS driver-assistance systems, this can compromise signal integrity and, consequently, the…

Read more
NIR filter blocks visible light for optical sensors

NIR filter blocks visible light for optical sensors

In sensors that use near-infrared (NIR) light, visible and ultraviolet light can interfere with detection. This is an issue in applications such as machine vision, iris scanners, LiDAR, time-of-flight modules, and other optical sensors. A filter…

Read more
RF absorbers reduce reflections in test setups and antenna designs

RF absorbers reduce reflections in test setups and antenna designs

Unwanted reflections are a recurring problem in virtually any RF environment: signals bouncing off a test chamber or crosstalk between antenna systems. With the ABS-SLF-F-x V, ABS Technics offers a fully enclosed, lightweight, carbon…

Read more
Flexible EMI/RFI Shielding for Complex PCB Layouts

Flexible EMI/RFI Shielding for Complex PCB Layouts

Tight PCB layouts, mixed-signal designs, and frequent design changes make it difficult to effectively protect sensitive circuits against EMI/RFI. A standard shield does not always match the final PCB layout, whereas a…

Read more
Ferrite Materials for Wireless Power Transmission

Ferrite Materials for Wireless Power Transmission

In wireless power transfer (WPT), ferrite materials are used to influence the magnetic flux field of the transmitter and receiver coils. Ferrite can direct the magnetic flux in the desired direction…

Read more
High-Power RF Amplifiers for Ground-Based Drone Detection Systems

High-Power RF Amplifiers for Ground-Based Drone Detection Systems

Ground-based RF systems for detecting drones typically operate at higher power levels than compact RF systems used in airborne platforms. Furthermore, the amplifiers used must cover a wide frequency range…

Read more
EMI/RFI Shielding in 5G Design

EMI/RFI Shielding in 5G Design

Designing 5G hardware presents new EMI/RFI challenges, particularly due to the introduction of the 60 GHz frequency. At short distances, there are many mmWave signals, tolerances are becoming tighter, and…

Read more
Reliable heat dissipation at minimal pressure

Reliable heat dissipation at minimal pressure

Chomerics is introducing a new generation of thermal greases for efficient heat dissipation in electronics applications. The THERM-A-GREASE series consists of four silicone-based variants with thermal conductivities of 1.5, 3.0, 5.0, and 7.0…

Read more
High-temperature EMI gasket for indoor electronics

High-temperature EMI gasket for indoor electronics

Parker Chomerics introduces SOFT-SHIELD 4860, a high-temperature, electrically conductive foam solution for EMI shielding. The material combines silver-coated nylon fibers with a low-density silicone foam, ensuring reliable Z-axis conductivity and cost-effective…

Read more